Skip to content

Free engineering tools

Engineering calculators.

Plan a PCB stack-up, size traces for current, and estimate what a board will cost to build. Everything runs in your browser.

Inputs

Board
Copper & dielectric
Thinner gives narrower 50 Ω traces and tighter coupling to the reference plane. Ignored for 2 layers.
Impedance targets
Edge-to-edge gap between the two traces. 0.127 mm = 5 mil.
Calculated thickness–target –
Layers––
Dielectric εr––
Status––

Stack-up cross-section

Change any layer between signal, ground and power. Not to scale for copper.

Trace widths for target impedance

First-pass estimates from IPC-2141 closed-form equations.

LayerStructureReferenceHeight to planeWidth · 50 Ω SEWidth · 100 Ω diff
Ask us to review this stack-up

Results are estimates for early planning: closed-form equations are typically within about ±10% of a field solver, and solder mask lowers outer-layer impedance by roughly 2–4 Ω. Always confirm the final stack-up and trace widths with your fabricator's impedance calculation before release.

Have a challenging electronics problem?

Tell us what you are building. We can discuss requirements, technical feasibility and the right development path.